30
W415-1283 / F / 04.30.18
EN
electrical information
battery back-up installation
A.
Remove the safety barrier and door, refer to the "main safety barrier removal / installation" and "main door
removal / installation" sections for detailed removal instructions.
B.
Remove the panel cover using the two finger holes, then remove the control panel cover by lifting it up
and off of the four shoulder screws. This will allow you to easily access the battery housing.
C.
Remove your battery housing to install the batteries, this will be located in the control compartment,
as shown below.
D.
Install the four
“AA” batteries, ensure the positive and negative ends correspond with those identified on the
battery housing.
E.
Place the battery housing back into position or let it rest on the hearth, for the duration of the power failure.
BATTERY
HOUSING
PANEL COVER
CONTROL
PANEL COVER
In the event of a power failure, your appliance can be operated using the supplied battery back-up.
note:
Once the power has been restored, remove the batteries from the holder. The system will drain the batteries if
they are left in the battery holder.
note:
