Contec LES-RACK, Руководство по эксплуатации и инструкция по установке, Страница: 38 / 54

38
cover plate has been lifted or deformed at the location of the tank. This is a case where the
device was already exposed to a higher temperature, but the pressure was not sufficient to
release through the safety valve. In such a case, we recommend consulting the manufacturer
or a trained entity about the situation.
Figure number 35 – Indicator of the Temperature limits
WARNING: Do not install the LES-RACK device and do not put it into operation if the
permitted temperature is exceeded or if the sheet metal cover is visibly deformed.
The device is designed for universal installation in all types of 19" cabinets. It is installed
exclusively with the front panel facing the door of the cabinet using special guide rails (fig.
no. 36), which are included in the product packaging.
First fix the guide rails to the cabinet with two M5 screws and clips. We recommend that the
assembly of LES-RACK device is carried out before the installation of other devices located
in the cabinet. In the case of limited space, at least two people should carry out the assembly.
LES-RACK can then be connected, together with any other external component connectors,
before or after inserting it into the guide rails and then screwed to the guide rail using 4 pcs of
M5 screws.
WARNING: When installing the LES-RACK in the cabinet, extreme care must be taken
due to the weight of the device and it must be done in such a way to not damage theh
device under any circumstances.
The the guide rails (fig. No. 36) are inserted between the front and rear 19th rack or between
the front 19th rail and the cabinet frame. On the front panel the guide rail has 3 holes with
M5 screw-thread with a spacing equal to the 1U drilling in the 19th rack.
Included in the package are screws and ratchet clips, intended for attaching guide rails. First,
fix the guide rails in place with two screws. A sliding foot with an M5 center hole is screwed
on the back of the guide rail for attachment to the rear rack or cabinet frame. On the front side
of the guide rail use a countersunk hole and a flat head screw. The remaining two holes are
used to attach the LES-RACK after it is inserted into the guide rail and pushed against the
face of the 19th. rack