—
Appendix
—
CPS-PC341MB-ADSC1-9201 Reference Manual (Hardware)
—
69
—
Item
CPS-PC341MB-ADSC1-9201
LED
Transmission (Yellow), Reception (Yellow)
Switch
DIP Switch (Full Duplex /Half Duplex, Terminator (ON/OFF))
Surge protection element
each signal - SG
Interactive TVS diode
Stand off voltage : ±13V, Peak pulse power : 400W(1msec)
Surge protection element
SG - FG
Gas discharge tube arrester
Discharge voltage : ±300V, impulse current tolerance :
2000A(8/20
μ
sec, 10 times)
USB
Transmission standard
USB2.0 standard follow
The number of channels
1
Connector
TYPE-A
SD card slot
Standard
SD standard follow
Connector
SD memory card slot
LED
Read/Write (Yellow)
RS-232C
Baud Rate
300bps - 115.2kbps
Isolation/Resistance
Non-isolated
Data length
5, 6, 7, 8bit 1, 1.5, 2stopbit
Parity check
Even, Odd, Non-parity
The number of channels
1
Connector
9-pin D-SUB connector (Male)
LED
Transmission (Yellow), Reception (Yellow)
Digital input/
Counter input
Input type
Opto-coupler Isolation Input (Compatible with current sink
output) (negative logic) *1
Isolation/Resistance
Bus Isolation /500VDC, Opto-coupler Isolation/1000V
Built-in power supply
12VDC
Input resistance
5.6k
Ω
Input ON current
1.6mA or more
Input OFF current
0.16mA or less
Response time
Within
200μ
sec *2
Interrupt (Digital input)
4 interrupt input signals are arranged into a single output of
interrupt signal. An interrupt is generated at the falling edge
(HIGH-to-LOW transition) or rising edge (LOW-to-HIGH
transition). (setting can be done by software)
The number of channels
4 (It is possible to allocate 2channels to counter input)
Count type
Up count
Max. count
FFFFFFH (binary data)
Counter response speed
1kHz (Max.), Duty: 50% (Max.)
Interrupt (Counter input)
One interrupt caused upon channel count match
Timer
None
LED
DI0 - DI3 (Yellow)
Surge protection element
each signal to B_COM
Interactive TVS diode
Stand off voltage : ±30V, Peak pulse power : 400W(1msec)
