7
1.
Place the staff microphone on the staff side of the counter top, ensuring
that it does not cause an obstruction and is as close to staff as possible.
2.
Place the amplifier under the staff counter, ensuring that it will not
obstruct staff when they are sitting.
3.
Mark the 4 fixing points for the amplifier under the counter.
4. Drill and fix the amplifier in place using the supplied screws.
5. Use the cable management hole to run the staff microphone cable back
to the amplifier. If there is not already a cable management hole, one will
need to be drilled in a suitable location near the rear of the counter.
Staff Microphone, Amplifier and Overhead Loudspeakers
Installation Instructions
Install the Staff Microphone, Amplifier, Overhead Loudspeakers, Bridge Bar
Unit and Surface Mic in the order described below. If you have followed
the steps closely and the system is not functioning as intended, consult
Troubleshooting on page 14.
Fixing points
