13
Once you have followed the above steps:
1.
Ensure staff microphone is no more than
300mm away from the staff member when
sitting.
2.
Check amplifier is fully functional by ensuring
the red ‘fault’ light is NOT showing on the front.
Initial Set-Up
To achieve the best possible performance, we recommend following the
below steps:
1.
Ensure the customer and staff volumes are turned completely down
2.
Adjust staff (Volume In) volume to a comfortable level
3.
Increase customer (Volume Out) volume until feedback is heard
4.
Decrease customer (Volume Out) volume until feedback is just eliminated
Factory Default Settings
To return to the factory default settings:
1. Unplug the power supply and then reconnect it.
2.
Press the “On/Off” button and Volume In - button together, then release.
3.
The status LED bar graph will show a fixed pattern of LEDs indicating the
firmware revision number, followed by all LEDs illuminated - this
indicates that the default settings have been restored.
If there is insufficient volume, enter Engineer Mode and raise max volume
settings, then exit Engineer Mode and repeat initial setup.
The system is now ready to use. Speak into the microphone to converse easily
through glass.
Staff
microphone
