Consilium SELUX ST, Инструкция по установке и обслуживанию

Страница: 116 / 180

TROUBLESHOOTING
5.1 Rev. E
CHAPTER 5
TROUBLESHOOTING
5.1 Introduction
This chapter provides the procedure that must be followed in order to replace a
fail component of the SELUX ST DISPLAY.
5.1.1 Safety Precautions
If not otherwise specified in the procedures, during the corrective maintenance
operations, the following safety rules must be observed:
each maintenance operation must be carried out only after the equipment
switching off;
WARNING
SET TO OFF THE MAIN BREAKER OF THE EQUIPMENT AND HANG TO
IT A PLACARD READING "WORK IN PROGRESS DO NOT SWITCH
ON".
before removing any component, be sure the spare part is available;
verify the integrity of the spare part and, if possible, perform a functional test.
5.1.2
Personnel
Skilled personnel with a good knowledge of the equipment must carry out the
replacement operations.
5.2 Required Tools and Instruments
To carry out the replacement operations described in this chapter, only normal
workshop tools (as screwdrivers, wrenches etc.) are required.
The tools required to perform the troubleshooting operations are:
•
set of cross and slotted screwdrivers;
•
set of socket and torx wrenches;
•
scissors;
•
Tweezers.