Conrad VC940, Руководство по эксплуатации

Страница: 16 / 21

Model VC940: OPERATING MANUAL
16
Chapter 5
Changing the Default Setting
Introduction
The Meter allows you to change the default operating configuration of the Meter by changing setup options made at the factory.
These settings are stored and can be changed in the Setup mode using the procedure described in this chapter.
Selecting Setup Options
To enter the Setup mode, turn the Meter on and press and hold RANGE button for over 1 second.
In the Setup mode, each press of Setup button steps to the next Selection. Each press of – or + button decrement or increment an Option.
Each Setup Selection and Option appears in the primary display in the sequence shown in Table 5-1.
Table 5-1. Setup Selections
Selection Option Factory
Default Description
HIGH Max. 40000
Press to select OFF
Press to select the digit you want
to edit OFF Over the upper limits, beeps not
continuously.
LOW Max. –40000
Press to select OFF
Press to select the digit you want
to edit OFF Over the lower limits, beeps not
continuously.
10 10 mins power off
20 20 mins power off
30 30 mins power off
OFF
10 mins
Power off feature is disabled
S1 Beeps continuously and icon lights on
OFF
S1
No beep, icon flashes
10 Backlight turn off in 10 seconds
20 Backlight turn off in 20 seconds
30 Backlight turn off in 30 seconds
OFF
10
Disable backlight feature.
Zero is in the left hand side.
Analogue Bar
Graph
Zero is in the center
Zero is
in the
center
It can only apply to DCV, DCI and C/°F
functions.
Saving Setup Options
At each setup Option, store your choice and exit setup by press EXIT , advance to the next Option by press +.
To exit the Setup mode without saving the present Option, press Setup .