Conrad STV-1280, Руководство по эксплуатации

Страница: 45 / 111

45
• “5. Full Scan”
With this option, you start the automatic station programming.
After termination of the search run, all detected stations are saved.
• “6. Channel Scan”
This has the same function as “5. Full scan”, but the TV box does not search the entire frequency
band for stations here but for a pre-programmed frequency list.
This may not detect some stations. If you notice that a station is missing, which should
be available, start the station programming with the function “5. Full scan” (see above).
4. Selecting the resolution of the TV box (“4. Resolution”)
The TV box can play back various resolutions and image refresh rates via its VGA output
depending on the connected monitor.
Please note:
If you set the resolution higher than your monitor is able to display, the TV box can no
longer display an image.
For example, if you have a TFT monitor with a resolution of 1024*768 pixels, do not set
the resolution to 1280*1024, as no image will appear!
In this case, turn the TV box off. Enter “000” with the IR remote control (press “0” three
times). The TV box changes back to the resolution 640*480 in 60Hz.
The following settings are possible:
Always operate TFT monitors with 60Hz, cathode ray monitors with 75Hz.
1. 640 x 480 60Hz
2. 800 x 600 60Hz
3. 852 x 480 60Hz
4. 1024 x 768 60Hz
5. 1280 x 1024 60Hz
6. 640 x 480 75Hz
7. 800 x 600 75Hz
8. 852 x 480 75Hz
9. 1024 x 768 75Hz
10. 1280 x 1024 75Hz 1. Input
2. Picture
3. TV Function
4. Resolution
5. OSD Function
6. Language
7. Reset