Conrad CV Mobil 4200 FM, Инструкция по эксплуатации

Страница: 25 / 32

7
•
Turn VOLUME control from OFF position slightly to clockwise position. LED
display will be illuminated. Then turn further until desired volume is reached.
Using the 40 Channels FM system (the former CEPT system)
Europe-wide you can use the 40 Channels in FM mode.
40 FM This is former “CEPT” mode, this is allowed in most countries (including
Austria). Here the radio works on the international 40 Channels in FM
mode. The Mode switch
AM – FM on the front side allows as well
receiving in AM and FM , but only transmitting in FM mode (in some
countries residents may still need a license, even for 40 CH FM only!)
Please read carefully the “Radio Passport” or the “Circulation Card” in the last
chapter of this manual before using the radio in unknown countries.
Selecting the operating channel
•
with Up or Down buttons on the radio you can continuously select channels. The
present channel is displayed.
•
Press the respective button longer to run up or down through the channels. The
present channel is displayed.
Adjusting squelch (muting)
Particularily in FM, noise can be a nuisance on a free channel. With the muting
control (
SQUELCH ) you can suppress this noise - but also signals which are too
weak to be received properly.
This is how to adjust the signal strength required to switch on the loudspeaker, using
the
SQUELCH control knob:
The further the control knob is turned clockwise, the stronger a signal has to be in
order to be audible through the loudspeaker.
In order to adjust the set to be the most sensitive to incoming signals, switch to a free
channel:
•
Use the UP / DOWN switches to find a free channel, where no signal is
displayed.
•
Then turn the SQUELCH control carefully to the right until the noise just
about disappears.
Now the loudspeaker stays off when on a free channel but it switches back on when
receiving even very weak signals.
The muting adjustment is particularly important during channel
scanning. In this mode the point to which the set is adjusted
decides whether scanning is stopped at the signal or not.