39
e) Copy Function
If you want to assume, e.g., Monday’s temperature curve for another or several other days,
it can be copied very easily. Therefore, you do not need to programme the same
temperature curve for several days.
Proceed as follows:
• Hold down the „
“ button (approx. 3 seconds) until the weekday or one of the day
blocks starts flashing. „COPY“ also flashes on the display. Then release the button.
• Select the day from which the data is to be copied with „
“ and „
“ (you cannot
select any day block, but only a single day).
• Confirm the selection with „
“. The display „COPY“ stops flashing.
• Now select the target with „
“ and „
“ (This also must not be any day block, but
only a single day). The current temperature curve is shown at the bottom of the display.
• Confirm selection with „
“ to copy the temperature curve data. The new temperature
curve appears at the bottom of the display.
• If the temperature curve selected in the beginning is to be transferred to another day,
select the other day with „
“ and „
“. Confirm your selection again with „
“.
• Leave the copy mode with „
“.
