ConMed Linvatec LS7500, Инструкция по эксплуатации

Страница: 12 / 24

8
2.0
MAINTENANCE
2.1 Cleaning
The following maintenance procedures should
only be performed by qualified service
personnel. Read all warnings and cautionary
notices carefully before performing any service
procedures.
WARNINGS:
1. The Xenon lamp is under extremely high
pressure; do not leave finger prints or
any marks on the lamp reflector surface
or the bulb. Do not subject the lamp to
mechanical forces or rough handling that
could fracture the lamp.
2. Disconnect the main power cord before
attempting any service to the lamp or
lamp connections.
1. Unplug the light source and allow it and the
fiber optic light guide to thoroughly cool
before cleaning.
2. The interior of the light source housing
must be kept free of dust and dirt around the
air intake and outflow vents. The interior of
the unit may be vacuumed or blown out
using an air hose as required.
3. Wipe the exterior of the unit and fiber optic
light guide with a clean, soft cloth damp-
ened (not dripping) with a mild detergent.
Wipe again with distilled or sterilized water.
Dry with a clean, lint-free towel.
2.2 Lamp Replacement
1. Turn the “POWER” switch off.
2. Unplug the light source. Wait at least 15
minutes for the lamp to cool before pro-
ceeding.
3. Wear a face shield or protective safety eye
glasses when handling the lamp. Do not
leave finger prints or any marks on the lamp
reflector surface or the bulb. Oil on these
areas, such as from fingers, will burn from
the heat and may cause damage to the bulb.
4. Turn the unit over and locate the lamp
access door. Slide the latch on the lamp
access door towards the front of the unit and
pull the door open.