ConMed Linvatec LS7500, Инструкция по эксплуатации

Страница: 7 / 24

3
25. Equipment grounding is vital to ensure safe
operation. Plug the power cord into a prop-
erly earthed mains supply outlet whose
voltage and frequency characteristics are
compatible with those listed on the unit or
in this manual. Do not use plug adapters or
extension cords; such devices defeat the
safety ground and could cause injury.
26. External equipment, that will be connected
to signal input and signal output ports or
other connectors, shall comply with rele-
vant IEC standard (i.e., IEC 60950 for IT
equipment and IEC 60601 series for medi-
cal electrical equipment). In addition, all
such combinations - systems - shall comply
with the standard IEC 60601-1 (Safety
requirements for medical electrical sys-
tems).
Any person who connects external
equipment to signal input and signal output
ports or other connectors has formed a
system and is therefore responsible for the
system to comply with requirements of
IEC 60601-1. If in doubt, contact a
qualified technician or your local
representative.
27. This equipment has been tested and found
to comply with the limits for medical
devices to the IEC 60601-1: 2000 2nd edi-
tion and IEC 60601-1-2 September 2001.
These limits are designed to provide reason-
able protection against harmful interference
in a typical medical installation. This equip-
ment generates, uses and can radiate radio
frequency energy and, if not installed and
used in accordance with the instructions,
may cause harmful interference to other
device(s) in the vicinity. However, there is
no guarantee that interference will not
occur in a particular installation. If this
equipment does cause harmful interference
to other devices, which can be determined
by turning the equipment off and on, the
user is encouraged to try to correct the
interference by one or more of the follow-
ing measures:
1) Reorient or relocate the receiving
device.
2) Increase the separation between the
equipment.
3) Connect the equipment into an outlet
on a circuit different from that to which
the other devices are connected.
4) Consult the manufacturer or field
service technician for help.