Copyright
©
2014
congatec
AG
TS87m13
71/124
Table 28 Module Type Definition Signal Description
Signal
Pin # Description
I/O
Comment
TYPE0#
TYPE1#
TYPE2#
C54
C57
D57
The TYPE pins indicate to the Carrier Board the Pin-out Type that is implemented on the module. The pins are tied on
the module to either ground (GND) or are no-connects (NC). For Pinout Type 1, these pins are don’t care (X).
PDS
TYPE[0:2]# signals are
available on all modules
following the Type 2-6
Pinout standard.
The conga-TS87 is based
on the COM Express
Type 6 pinout therefore
the pins 0 and 1 are not
connected and pin 2 is
connected to GND.
TYPE2#
TYPE1#
TYPE0#
X
NC
NC
NC
NC
GND
X
NC
NC
GND
GND
NC
X
NC
GND
NC
GND
NC
Pinout Type 1
Pinout Type 2
Pinout Type 3 (no IDE)
Pinout Type 4 (no PCI)
Pinout Type 5 (no IDE, no PCI)
Pinout Type 6 (no IDE, no PCI)
The Carrier Board should implement combinatorial logic that monitors the module TYPE pins and keeps power off
(e.g deactivates the ATX_ON signal for an ATX power supply) if an incompatible module pin-out type is detected.
The Carrier Board logic may also implement a fault indicator such as an LED.
TYPE10# A97
Dual use pin. Indicates to the carrier board that a Type 10 module is installed. Indicates to the carrier that a Rev.
1.0/2.0 module is installed.
PDS
Not connected to indicate
“Pinout R2.0”.
TYPE10#
NC
PD
12V
Pinout R2.0
Pinout Type 10 pull down to ground with 4.7k resistor
Pinout R1.0
This pin is reclaimed from VCC_12V pool. In R1.0 modules this pin will connect to other VCC_12V pins. In R2.0 this
pin is defined as a no-connect for Types 1-6. A carrier can detect a R1.0 module by the presence of 12V on this pin.
R2.0 module Types 1-6 will no-connect this pin. Type 10 modules shall pull this pin to ground through a 4.7k resistor.
Table 29 Power and GND Signal Descriptions
Signal
Pin #
Description
I/O
PU/PD Comment
VCC_12V C104-C109
D104-D109
Primary power input: +12V nominal. All available VCC_12V pins on the
connector(s) shall be used.
P
GND
C1, C2, C5, C8, C11, C14, C21, C31,
C41, C51, C60, C70,C73, C76, C80,
C84, C87, C90, C93, C96, C100,
C103, C110, D1, D2, D5, D8, D11,
D14, D21, D31, D41, D51, D60, D67,
D70, D73, D76, D80, D84, D87, D90,
D93, D96, D100, D103, D110
Ground - DC power and signal and AC signal return path.
All available GND connector pins shall be used and tied to carrier board GND
plane.
P
