39
6.2
MOUNTING THE BUILT-IN ROTARY FLANGE
Install using the supplied built-in rotary flange. The built-in rotary flange is used as a connecting element
between the pipe and the backwashing filter. It is suitable for both horizontal and vertical pipes.
The built-in rotary flange must be installed in the direction of flow. This is marked by a
cast in arrow (see fig. 5).
The flange surface of the built-in rotary flange must be in a vertical position! The built-in rotary flange must
be fitted so that mechanical stresses cannot occur!
Otherwise mechanical damage can result, the pipe may burst or the built-in rotary flange can break. This
can result in major water damage. In this case, persons close to the backwashing filter are exposed to a
health risk due to the large quantities of water.
Therefore, during installation, ensure that no large forces act on the pipe, built-in rotary flange and back-
washing filter.
The section of the profiled flange gasket must point towards the built-in rotary flange (see fig. 5). Failure
to observe this can lead to leaks and water escaping. This can in turn cause water damage to the house and
its installations.
Fig. 5: Built-in rotary flange
Failure to comply with this means that backwashing is impossible. By and by this
leads to an increasing pressure loss.
Profiled flange gasket
Flow direction arrow
Содержание CLEAR 2.0 R 1 1/4"
Страница 16: ...16 Abb 7 Ableitungsm glichkeiten f r das R cksp lwasser I min 10 l II min 20 mm III IV V min 250 mm min 250 mm...
Страница 42: ...42 Fig 7 Backwash water discharge options I min 10 l II min 20 mm III IV V min 250 mm min 250 mm...
Страница 68: ...68 Rys 7 Mo liwo ci odprowadzenia pop uczyn I min 10 l II min 20 mm III IV V min 250 mm min 250 mm...
