Conel CLEAR 2.0 K 1, Руководство по эксплуатации

Страница: 40 / 80

40
6.3
MOUNTING THE CARTRIDGE FILTER
The built-in rotary flange for the cartridge filter is supplied with bayonet drill holes. The necessary seals
and screws for this cartridge filter have already been mounted.
Do not unscrew the screws!
/
Insert the four flange screw heads through the bayonet drill holes on the built-in rotary flange (see
fig. 6 I).
/ Turn the cartridge filter in a clockwise direction as far as it will go (see fig. 6 II).
/ Tighten the two screws in the front alternately with an Allen key (see fig. 6 III).
The pipes must be able to safely support the cartridge filter. Otherwise mechanical damage or fractures/
bursts can occur in the pipes. This can result in major water damage.
Persons close to the cartridge filter are exposed to a health risk due to the large quantities of water re-
leased.
Therefore, if necessary, the pipes must be additionally fixed or supported.
Select the torque (approx. 6 Nm) so that the gasket closes and the cartridge filter
is not damaged or strained!
Fig. 6: Installing the cartridge filter
The unit may only be installed by skilled personnel. The chapter 4.1 “INTENDED
USE” must always be observed!
I II III
2.
1.