PC-POD-CP-006-v01
PC-POD-CP-006-v01
Printed copies are not controlled.
Page
28
of
35
NOTE: The minimum time is 128 seconds and the maximum possible time is 1024
seconds.
9.3.12
Under BP Control make sure “SunTech
Tango” appears.
9.3.13
Select “Auto Start/Stop Continuous Mode” when it is important that EA data
samples be acquired at preset intervals over a finite length of time.
9.3.14
Select “BP Result Initiates Block or One-Shot Mode” to be able to control
output data acquisition through the BP monitor’s interval times and/or clicking
the “READ” BP control button.
9.3.15
Select “Manual Mode” in order to collect COP/HRV data and BP data that is
independent of each other.
NOTE: If “Manual Mode” is selected, make sure to program the SunTech
Tango. To
do so, press on the main menu button
select “Measurement Setup”
select
“Interval”
using up and down arrows select interval desired. This may or may not
be the same interval for EA samples.
NOTE: In this mode BP will only be collected when the “READ” button is clicked in
the “Acquisition Window” or when another reading is initiated by the monitor’s
internal timer.
9.3.16
Under “BP Value Valid For”, set the length of time that BP values are to be
considered valid.
Main menu
button
