Concept2 VP9171, Руководство по эксплуатации

Страница: 30 / 40

28 VP9171
EN
DUST RETENTION BAG FILL CHECK
When the dust retention bag fill indicator becomes red during operation, replace the full dust retention bag
immediately.
Note: If the dust retention bag fill indicator is still red after the the bag replacement, it may be due to several causes:
- Some of the air passages (hoses, telescopic tube, suction inlet, brush adapter, or other adapters) are obstructed;
- Motor filter is dirty;
- Air outlet filter is dirty.
Check for each of the above possible causes and eliminate the problem before you resume vacuuming. If the cause of
the problem cannot be identified, hand over the appliance to the nearest service centre. Never use the appliance if the
dust retention bag fill indicator is completely red. The motor could be damaged irreparably.
CLEANING AND MAINTENANCE
You can clean the accessories and the appliance with a wet cloth. Never immerse
the appliance
in water! Do not use any aggressive substances for cleaning, such as solvents or
abrasives!
DUST RETENTION BAG REPLACEMENT
1. Unplug the product from the mains. Disconnect the hose from the suction inlet
and open the appliance cover.
2. Push the safety flap on the dust retention bag holder, remove the used dust
retention bag (Fig. 3). Discard the paper or SMS bag. Make sure it does not get
ripped open when handled.
Empty and carefully close the fabric bag - it can
be used repeatedly.
3. Insert a new or empty dust retention bag by fitting the plate in the bag holder. The
bag opening must be aligned with the hose hole in the appliance cover.
4. Only use the appliance when the dust retention bag is present! If you forget to
insert the dust retention bag or you place it incorrectly, the appliance‘s motor may
get damaged.
5. Close the cover by pushing it until it clicks in the right position.
FILTER REPLACEMENT
• Filters should be cleaned or replaced when they are visibly dirty, or the appliance‘s
suction power is reduced. Check the filters after every use of the appliance.
• In order not to damage the appliance, do not use it with an incorrectly fixed filter.
• Before replacing the filters, disconnect the appliance from the electric voltage
outlet.
• You can buy suitable types of filters from your dealer, or you can order them with
the manufacturer.
MOTOR FILTER CLEANING AND REPLACEMENT
1. Disconnect the flexible hose and open the appliance‘s cover.
2. Pull the dust retention bag out of its holder so that you can access the motor filter
more easily.
3. Remove the motor filter (Fig. 4). You can clean the filter by tapping and shaking. If
full of dirt, you can wash the filter in lukewarm water and let it dry properly.
(Fig. 3)
(Fig. 4)