EN
EN
91
90
VR2010
VR2010
Side brushes
You can easily check the side brush condition and if necessary,
remove the dirt
• Turn the vacuum robot upside down.
• Remove the screws with a screwdriver.
• Use scissors to remove hair and other dirt.
Side brush bristles can be damaged (frayed) during transport or by
while in unsuitable conditions. Inserting the bristles in hot water
will straighten them to their original state.
In case of damage to the side brushes, they can be replaced with
a new one. Replacement side brushes may be performed by an
authorized service centre.
• Turn the vacuum robot upside down.
• Remove the screws with a screwdriver.
• Remove the damaged brush and replace it with a new one.
• Tighten the screw using a screwdriver.
Warning:
Make sure the brush is placed on the right side of the vacuum robot
The main brush
To remove the brush from the cover, push the brush cover release lever. Then clean the brush from hair and
other dirt.
OK
renewable
Replacement necessary
Dust bin and cloth filter
In order to extend the service life of the vacuum robot, clean the dust bin and the cloth filter each time you use it.
The content of the dust bin greatly affects the suction power of the vacuum robot and the quality of the cleaning.
Release the dust filter cover (Fig. 1) and clean the filter place and the filter.
Clean the dust bin and empty the trash into the waste bin.
Remove the filter (Fig. 2) and clean it (wash and dry it before using again).
Fig. 1
Fig. 2
Warning:
NEVER
wash the dust bin with water, the suction motor is inside the container. Water could damage the suction
motor The water tank can be washed with water.
Sensors and charging poles of the vacuum robot
Clean the sensors and charging poles once a week to ensure proper operation of the appliance.
