EN
EN
87
86
VR2010
VR2010
SIDE VIEW
1. Dust bin button
2. Dust bin / water tank
3. ON/OFF button
4. Power socket
DUST BIN
1. Water tank
2. Suck passage
3. Suction motor
Warning:
Never wash the dust bin with water,
the suction motor is inside the container.
Magnetic strip
Place a magnetic strip in places, where you
do not want the vacuum cleaner to enter.
Remote control
1. ON/OFF button
2. Automatic mode
3. OK button – to confirm the
selection
4. Edge cleaning path mode
5. TIME SETTING
6. Sound ON/OFF button
7. Recharging button – the vacuum
cleaner searches for the charging
station
8. Direction buttons
9. FULL GO mode
10. Circular mode
11. Plan button
1
2
3
4
1
3
2
1
2
3
4
5
6
7
8
9
10
11
BEFORE FIRST USE
1. Insert the batteries into the remote control.
2. Apply the cleaning brushes as indicated by R and L.
3. Connect the charging base to an electrical outlet using the AC adapter. Place the charging base against the
wall and remove obstacles about 1 meter at two sides and 2 meters forward. The indicator light must light
up when connecting to a mains power supply. It is recommended to fix the charging base to the floor, e.g.
by double-side mounting tape. Place the power supply cable so to avoid tangling of the vacuum cleaner.
4. Place the vacuum robot onto the charging base.
5. The vacuum robot battery will start charging automatically. Allow the battery to charge for more than
6 hours before first use. The charging status flashes on the display, it will stop flashing after the battery if
fully charged. If the battery is near the discharge point, the vacuum cleaner will automatically search for
the charging base.
6. Before using the vacuum robot, please remove any objects from the floor that can prevent the vacuum
robot from operating (cables, chairs, small items, inappropriately placed carpet, etc.)
Cleaning mode
– the ON/OFF button is in the ON position, the display panel is ON.
Stand-by mode
– the ON/OFF button is in the ON position, the display panel is ON and the vacuum robot does
not operate. To activate it, press any cleaning mode button.
Sleep mode
– the ON/OFF button is in the ON position, the display panel is ON. The vacuum robot enters this
mode automatically after 45 seconds of inactivity.
TIME SETTING
Make sure that the vacuum robot is ON and not charging.
To set the time, press the button
on the remote control. First two digits begin to flash to set the time. To
set the values, use the
˄ ˅
buttons. To confirm the time, press the
OK
button. Then the right side of the display
starts to flash to set the minutes. Follow the same steps as the hour setting.
Charging status
Battery charging
Discharge of the battery
almost complete