EN
70
KTV3344
the appliance mains outlet.
• Set all controls in the OFF position.
• Wait until the inside of the appliance is no longer hot but remains lukewarm – cleaning is easier than when it is
cold.
• Clean the outer surface of the appliance with a damp cloth, soft brush or fine sponge and then wipe it dry.
• The inside of the oven can be wiped with a damp cloth, soft brush or sponge. In the case of heavy dirt, use hot
water with a non-aggressive detergent.
• Do not use coarse abrasive cleaning agents or sharp metallic scrapers since they may scratch the surface or the
glass may be broken.
• Never leave aggressive or acidic substances (lemon juice, vinegar) on the enamelled, varnished or stainless parts.
• Do not use an autoclave to clean the appliance!
• The baking pans may be washed in a dishwasher.
APPLIANCE INSTALLATION
• Only the customer, not the manufacturer, is responsible for the appliance installation. Defects caused by incorrect
installation are not covered by the warranty.
• Do not lift the appliance by holding it by the handle of the door!
• CAUTION!
Some edges of the appliance that are hidden after the installation may be sharp! Proceed with caution
to prevent an injury!
• The manufacturer bears no responsibility for damage caused to people, animals or objects as a result of incorrect
installation.
• To ensure correct function of the appliance, install it in suitable furniture.
• The appliance should be installed in standardised kitchen furniture designed for built-in appliances or in properly
adapted furniture of dimensions according to Fig. 1a, 1b.
• The kitchen furniture must be made of sufficiently heat-resistant material. The materials and adhesives used must
be resistant to heating of the appliance according to standard ČSN EN 60335-2-6. Materials and adhesives that do
not meet the stated standard may deform or loosen.
Connecting to the electric power source
• Make sure the mains voltage and current protection correspond to the values on the rating plate. We recommend
using a separate outlet circuit with a 16A circuit breaker.
• Use earthed wall outlets only.
• Do not use adapter plugs, connectors or extension cables. They could create a risk of fire due to overheating.
• The supply cable plug or circuit breaker have to be freely accessible even after the installation of the appliance. The
distance between opened contacts of the respective circuit breaker, or another breaking element, must be at least
3 mm.
• Only a qualified expert can perform connection changes.
• The electrical safety of the appliance can only be guaranteed if the protective terminal of the appliance is connected
to the protective conductor of the mains.
• The manufacturer bears no responsibility for damage caused to people or objects as a result of a missing or bad
protective connection.
• The power cord must be located so that it does not come into contact with hot parts of the appliance and so that
