A 600 mm
B 565 mm
C 560 mm
D 90 mm
E 24 mm
F 5 mm
G 118 mm
H 113 mm
J 80 mm
K 70 mm
L 25 mm
EN
39
ETV2160
Fig. 1a
Fig. 1b
Fig. 2
Removal
To uninstall the unit, it is important to proceed correctly:
1. First, unplug the power cord from the mains (pull out the plug or switch off the circuit breaker).
2. Remove the attachment screws.
3. Slide out the unit and at the same time pull out the power cord carefully.
SERVIS
Bulb replacement
The bulb of the internal space lighting is special, with high thermal resistance (25 W,
300 °C).
To replace it, proceed as follows (Fig. 2):
• Pull the power cord out of the mains outlet or switch off the circuit breaker of the
unit’s mains outlet.
• Unscrew the covering glass and replace the bulb with a new one of the same type!
• Screw the covering glass back in place.
3. Put the unit on the edge of the cabinet and run the power cord through the rear wall of the cabinet so that its
plug is accessible after installation.
4. Push the unit carefully to the selected place in the cabinet. Be careful not to squeeze the power cord.
5. Attach the unit to the cabinet by screwing 4 screws in the holes in the side walls of the unit. The holes can be
seen after opening the door.
6. Plug the supply cable into the wall outlet.
