Comtrol DeviceMaster Up, Руководство по установке оборудования

Страница: 43 / 56

RedBoot Procedures DeviceMaster UP User Guide : 2000451 Rev. C - 43
Uploading Firmware
Uploading Firmware
Use the appropriate procedure for your environment:
• Serial Method) on Page 43
• Telnet Method) on Page 45
Serial Method) The procedure for updating the Bootloader and SocketServer are the same, but the
.bin files are unique.
1. Verify that you have the
.bin
file ( Latest Firmware on Page 43) and cable
Establishing a Serial Connection on Page 39).
2. Connect a null modem cable from an available COM port on your PC to Port 1
on the DeviceMaster UP.
3. Start the terminal program and configure your terminal server program (for
example, HyperTerminal or MiniCom) to the following values:
• Bits per second = 57600
• Data bits = 8
• Parity = None
• Stop bits = 1
• Flow control = None
4. Reset the DeviceMaster UP (disconnect and reconnect the power cable).
5. Immediately type #!DM and press Enter in your terminal program.
6. At the
RedBoot>
prompt, type
dis
, and press
Enter
.
Note: If you are unsuccessful in disabling the Bootloader within ten seconds,
type
reset , #!DM , and dis again. The #!DM command is the only case-
sensitive command and must be in uppercase.
7. Verify that the system responds with an
Loading disabled
message.
8. Type load -r -b 0 -m x at the RedBoot> prompt and press Enter .
9. Upload the file using Xmodem for the
protocol. For example, if you are using
HyperTerminal:
a. Select
Transfer
.
b. Select Send File .
c. Browse to the location where you
stored the file from
Latest
Firmware on Page 43.
d. Select Xmodem as the protocol.
#!DM
RedBoot> dis
Loading disabled
RedBoot> load -r -b 0 -m x
CC
The file name in this screen shows the
Bootloader.