Comtrol DeviceMaster Up, Руководство по установке оборудования

Страница: 14 / 56

14 - DeviceMaster UP User Guide : 2000451 Rev. C Hardware Installation
Attaching the Network and Serial Cables
4. Optionally, attach the light pipes. The following light pipes have been tested
and found to function; Bivar, Inc. (P/N:LP-230) and Ledtronics, Inc.
(P/N:LTP003-0CW-001).
After mounting the DeviceMaster UP, you are ready to connect the cables.
Attaching the
Network and Serial
Cables Use the following procedure to attach the serial ribbon and Ethernet cables. For a
larger illustration of the system, see
1-Port Embedded on Page 36.
1. Attach the ribbon cable built in Building the Serial Ribbon Cable on Page 12
to the header labeled
J2
.
2. Connect a standard Ethernet cable from the RJ45 port on the DeviceMaster
UP to your Ethernet hub or a crossover cable to a server NIC.
The default port setting on the DeviceMaster UP is RS-232. Do not
connect the serial device until you have configured the serial port
settings. You must configure network settings and upload firmware
before configuring the serial port settings.
Use the next subsection to wire the power terminal connector and verify the
hardware installation.
Connecting the
Power and Verifying
Installation Use the following procedure to wire the power
terminal connector and connect the
DeviceMaster UP to a power source.
1. Connect the screw terminal power
connector to the wires as displayed in the
image.
The locally-supplied power supply must
conform to the specifications provided in
Power Supply for the 1-Port on Page 32.
Observe proper ESD techniques when connecting and disconnecting
the DeviceMaster UP.
2. Use a small flat head screw to lock the wires into place.
Ethernet
10/100
Connector
J2
1 2
9 10
Caution
Earth Gnd
Return
Positive
5-30VDC
+
-
Wire gauge:
AWG 12-22
Screw Terminal Power Connector
Caution