Comtech EF Data Memotec NetPerformer SDM-8400, Руководство по установке оборудования

Страница: 29 / 78

Hardware Installation
Memotec 3-7
Follow this procedure for wiring the DC power connector:
1.
Place the -48V wire into the first position on the left. Fasten the retaining screw (just
above the opening) to secure the wire into place.
2.
Connect the return wire to the middle position. Fasten the retaining screw to secure
the wire into place.
3.
Connect the ground wire to the last position (on the right). Fasten the retaining screw
to secure the wire into place.
NOTE:
Be sure to connect the RTN to GND on the user side.
4.
Place the plug component into the bottom cover of the cable housing. See
Figure 3-5 .
5.
Pass the tip of the tie wrap down through one of the openings at the bottom cover of
the housing. Run it underneath, then pass the tie wrap up through the second opening.
Fasten the tie wrap to itself and snugly over the wire, securing it into place. See
Figure 3-3
for what the end result should look like.
6.
Close the housing by lining up the tabs on the top cover with the bottom cover. Gently
push the two halves together until they click into place
.
Warning:
Do not remove the cover of the SDM-8400. The SDM-8400 unit
contains no user-serviceable parts. Only a qualified technician approved by
Memotec is authorized to open the unit.
Figure 3-4: Wiring the DC connector
Figure 3-5: Power Cords for SDM-8400 UAC Unit
Top
Bottom
Tie Wrap