Computer Concepts Eagle M2, Руководство пользователя

Страница: 55 / 66

8. Ifproblems occur...
You should continue to hear your sound source through the
internal speaker. The incoming waveform should be displayed. You
can now adjust the volume of the incoming signal using
Sampling
Lineln
on the mixer panel. Adjust this so that the waveform is as
large as possible without 'clipping' (touching either the top or the
bottom of the display).
If you can no longer hear your sound source, then you have set up
the mixer panel incorrectly.
If you can hear the sound source but nothing appears in the
AudioWorks sample display, then you have probably not set up
AudioWorks properly.
When you are satisfied, click on
Stop.
Press Play and you should
hear your sound source played back.
If you wish to record a movie with sound, then you should follow
the same procedure. However, you cannot alter the
LineIn
setting
whilst recording a movie (or when recording in AudioWorks with
High Quality on). Thus you must set the level before using the
above procedure.
Sound output does not work
This procedure works only if the audio ribbon cable is connected.
You therefore cannot use this test on an A3000.
Check the computer's internal sound system is switched on. See
Cannot record sound
for details.
Now load
AudioCtrl
and display the mixer controls. Check the
mute switch is not selected, and drag the slider for
Playback
internal
to full volume, and set the playback gain setting to high.
Now load
AudioWorks,
and double-click on a sound sample such
as
BellString.
This loads the sample into AudioWorks. Click Menu
on the AudioWorks icon and choose Preferences. A window should
appear: Click on the
Devices
icon to open the
Device preferences
window. Click Menu over the playback device, and select Eagle M2
44.1kHz st. Click OK.
Now select Repeat play in the AudioWorks sample window and
press Play. The play cursor should move indicating the sample is
playing.
48