Computer Concepts Eagle M2, Руководство пользователя

Страница: 18 / 66

2. Installation
...on
an Archimedes 300 & 400 series
The cable plugs into connector PL2 on the far
right of the Archimedes circuit board, partly
under the right-hand expansion card (looking
from the front of the machine). Note that the
cable turns through 180° (a half-turn) so the
rearmost pin on the Eagle card connects to
the frontmost pin on the Archimedes
circuit board.
There may be two plastic-covered links on
PL2. Remove them but keep them in a safe
place. You may need them in the future if
you change your monitor. The Archimedes
User Guide gives more details. (Look under
Connecting the monitor.)
...on
an Archimedes 400/1 series
This is similar to the 300 series except that PL2
is towards the centre of the circuit board,
partly under the left-hand expansion card.
...on
an Archimedes 540
The cable plugs into connector LK9, which
is towards the rear of the Archimedes circuit
board (looking from the front of the machine)
. Note the orientation of the cable as shown
in the diagram.
11