By Firstech, LLC 20
21 By Firstech, LLC
a@iM
Remote LCD(liquid crystal display) Diagram and lcons
Shock Sensor Bypassed
This icon will be displayed when the shock sensor is bypassed by pressing buttons I+III for 2.5 sec. Impact to the vehicle will not be
detected at this time. This icon is always displayed on starter only systems because there is no shock sensor.
Voltage
This icon will be displayed while the remote is reporting the voltage of the vehicle or remote battery.
Temperature
This icon will be displayed while the remote is reporting the temperature of the vehicle.
General System Functions
The remote transmitter functions have been predetermined and programmed from the factory. The four button configuration allows for many functions
to be performed through a series of tapping, holding and / or multiple presses of buttons. Although CompuStar remotes have numerous button functions
and capabilities, please keep in mind that the most common functions are performed in one simple step.
Sending Commands
When in range, and a command has been sent, the remote pager backlight will illuminate, the remote will beep and the appropriate icon will be
displayed. For example, to send a remote start command from the pager, hold down button (II) for 2.5 seconds. The backlight will illuminate and the
remote will beep once to confirm the command has been sent and that the remote is in range. Once the vehicle has successfully remote started, the
remote will receive a command indicating the vehicle is running.
Receiving Commands
The remote pager will receive commands indicating the status of the vehicle, confirmation of sending commands and alarm notifications. For example,
after sending the lock command, the pager will be updated with the lock icon to confirm the vehicle has been successfully locked/armed. To see if your
pager is in range to receive commands, tap button (IV) for 0.5 seconds - if the pager backlight illuminates and beeps, the pager is in range to receive
commands.
Not
Available
