Connectors, Switches, Security Override Jumper and Status LED Indicators
5-8
Compaq ProLiant DL360 Generation 2 Server Maintenance and Service Guide
COMPAQ CONFIDENTIAL
Codename: Maisto Part Number: 233831-001 Last Saved On: 12/12/01 10:24 AM
A warning message will be displayed on the iLO Web pages indicating the iLO Security
Override function is currently active. An iLO log entry will be added recording the use of the
iLO Security Override. An SNMP alert may also be sent upon setting or clearing the iLO
Security Override function.
In the unlikely event it is necessary, enabling the iLO Security Override also enables the iLO
boot-block to be flashed. The boot-block will be exposed until the iLO is reset. Compaq
recommends the iLO be disconnected from the network until the reset is complete.
To reset the iLO Security Override Jumper:
1. Power down the server. See “Powering Down the Server” in Chapter 2.
2. Remove the server from the rack. See “Removing the Server from the rack” in Chapter 2.
3. Remove the server access panel. See “Server Access Panel” in Chapter 2.
4. Remove the Security Override Jumper from the rear and center pins of J29 and place it
between the front and center pins.
5. Replace the server access panel and put the server back into the rack by reversing steps 2
and 3.
6. Press the Power/On Standby switch to power on the server and resume normal operation.
