Removal and Replacement Procedures
Compaq ProLiant DL360 Generation 2 Server Maintenance and Service Guide
2-33
COMPAQ CONFIDENTIAL
Codename: Maisto Part Number: 233831-001 Last Saved On: 12/12/01 3:47 PM
To remove a SDRAM DIMM:
1. Power down the server. See “Powering Down the Server” in this chapter.
2. Remove the server from the rack. See “Removing the Server from the Rack” in this
chapter.
3. Remove the access panel. See “Server Access Panel” in this chapter.
4. Press both SDRAM DIMM slot latches outward
.
5. Lift the SDRAM DIMM from the socket
.
1
1
2
Figure 2-29: Removing an SDRAM DIMM
Reverse steps 1 through 5 to replace a SDRAM DIMM.
IMPORTANT:
A memory module can be installed only one way. Be sure to match the key slots on the
module with the tabs on the memory slot. Push the module down into the slot, ensuring that the module
is fully inserted and properly seated.
IMPORTANT:
DIMMs must be installed in pairs and be of the same size.
IMPORTANT:
DIMMs must be 133-MHz registered SDRAM, 3.3-volts, 72-bits wide, and ECC.
