Compaq 222863-001 - TaskSmart W2200 Model 10, Руководство по техническому обслуживанию и ремонту

Страница: 34 / 92

Removal and Replacement Procedures 2-19
Ultra ATA/100 Controller Module (Model 10)
To remove the ATA controller module:
1. Power down the server. See “Powering Down the Server” earlier in this chapter.
2. Remove the access panel. See “Access Panel” earlier in this chapter.
CAUTION: Prevent damage to the connector pins by lifting the ATA controller module evenly
and with equal pressure on the board. Tilting the board causes the connector pins to bend.
3. Remove the ATA controller module by pinching the tops of the support posts
, and then
carefully lifting the ATA controller module from the system board
.
4. Disconnect the ATA cable from the ATA controller connector on the
module
. See
“ATA Cable (Model 10)” later in this chapter.
1
3
2
3
Figure 2-14. Removing the ATA controller module from the system board (center wall removed for
clarity)
To replace the ATA controller module, reverse steps 2 through 4, ensuring that the ATA
controller module securely seats on the support posts.