9.
Electri
cal Testing
Electrical Testing
This procedure outlines how to perform an electrical operations test on the OPT before
carrying out a full site test.
Once the power and comms terminations have been completed, check all terminals, plugs
and chips inside the unit to make sure they have not become loose during transit.
Site information provided to the factory may have been entered into the unit to help with
commissioning, but all settings must be checked when on site to make sure they are
correct.
CAUTION:
Some of the options shown below and described in this section may not appear
in certain configurations. The numbers used to select the options may change with different
versions of software.
NOTE:
Ensure all terminations are secure and made to the copper wire, not to the
insulation.
System Power Up
▪
Turn on the main circuit breaker inside the OPT then turn on the power switch on
the UPS board. When the unit is turned on, two LEDs above the power switch
should turn on. LED labelled D5 indicates the 230V mains power is OK, D6
indicates the battery is connected and OK.
▪
If D6 does not light up when then unit is first turned on it may be because the
battery has discharged during transport and storage or that the battery terminals
have become loose. If this happens, remove the battery from the holder and check
that the battery terminals are secure and then re-install it. If D6 still does not light
up leave the unit connected to the 230V supply for an hour or so to charge the
battery and then re-check.
▪
Check the Router or ADSL modem is turned on and the power LED is lit.
▪
Check the green power led on the right side of the Compac Box is on. If not, check
the switch on the left-hand side of the box is turned on.
Communications
Check that the ATG and Pump Communications LEDs on the FMS Board are lit.
LED
Colours
Comment
Pump Com's (NZ)
Yellow Green Red
Toggles Yellow / Green = Normal
Red = Comm's short
Pump Com's (Aus)
Green Red
Toggles Red Green = Normal
ATG (NZ)
Green Red
Toggles Red Green = Normal
ATC (Aus)
Green Red
Toggles Red Green = Normal
