11.
SERVICING
Tools
Having all the correct tools will make installation, upgrade, and repair procedures easy and
minimise the risk of damage to components.
Before you arrive on site, make sure you have a minimum of all the tools listed here.
▪
5.5mm nut driver
▪
7mm nut driver
▪
8mm nut driver
▪
T30 Torx drive bit or driver
▪
T10 Torx drive bit or driver
▪
Metric spanner set
▪
Metric 3/8" or 1/4" drive socket set
▪
1/4" screwdriver bit holder
▪
1/4" A/F spanner
▪
6" adjustable spanner
▪
Flat blade screwdriver set (1.5 - 5mm blades)
▪
#0, #1, #2 Phillips screwdrivers
▪
#1, #2 Pozidriv screwdrivers
▪
Set of metric Allen (hex) keys
▪
Fine long nose pliers, side cutters & pliers
▪
Hacksaw
▪
Stanley knife or similar sharp blade
▪
Felt tip pen or marker
▪
Glue - Loctite 601 or similar
▪
Insulating tape and masking tape
▪
Spray bottle of water and detergent
▪
Ruler
▪
Multimeter
▪
Isopropyl alcohol wipes, cleaning spray and cloths, baby wipes for cleaning
▪
Flat Precision screwdriver 0.23 x 1.5 mm tip
Biannual Service
▪
Clean or replace the ventilation filter.
▪
Check the ventilation fan runs smoothly and without abnormal noise.
▪
Check the UPS by powering down the unit at the mains switch and timing how long
before the unit switches off. If the unit turns off in less than 20 minutes the battery may
need replacing.
▪
Ensure the printer has sufficient paper.
Annual Service
▪
Check the seals on the COM5 PT1 door are not damaged or worn and that the COM5
PT1 base is secure.