Comnet CNGE11FX3TX8MS, Инструкция по установке и эксплуатации

Страница: 253 / 314

INS_CNGE11FX3TX8MS[POE][HO] Rev. 11.6.17 PAGE 253
INSTRUCTION MANUAL CNGE11FX3TX8MS[POE][HO]
TECH SUPPORT: 1.888.678.9427
interface 2.5GigabitEthernet 1/2
!
interface vlan 1
ip address dhcp fallback 192.168.10.2 255.255.0.0
!
line console 0
!
line vty 0
!
! [...]
!
end
my-device#
Lines that begin with ‘!’ are comments. The file begins with the hostname command and the
password for the admin user, followed by VLANs 1 and 42 and other items, such as Spanning
Tree Protocol (STP). A list of all port interfaces on the device, ordered by switch ID, type, and port
number comes next.
All port interfaces are at default settings, so nothing is displayed for them. As a general rule, only
non-default configuration is displayed, otherwise the output would be huge and readability would
suffer. There are a few exceptions that will be discussed later.
Following the physical interfaces are VLAN interfaces 1 and 42. Only the former has an IP address
assigned. Finally, the line section is shown. It specifies characteristics for the serial console (line
console 0) or network ICLI management connections (line vty x).
The configuration as displayed above is also what is saved to startup-config. my-device# copy
running-config startup-config
Building configuration...
% Saving 1326 bytes to flash:startup-config
my-device# dir
Directory of flash:
r- 1970-01-01 00:00:00 648 default-config
rw 1970-01-03 18:21:28 1326 startup-config
2 files, 1974 bytes total.