CommScope FOSC-350C, Инструкция по установке

Страница: 6 / 12

5.8 Make sure the ring tree in the slot and secure the
cable.
5.9 Secure the cable with UV-resistant tie wrap
5.9.2 Install a cable plug (hole towards outside) in all unused
closure cable ports.
6
6 .1
6 .1.1
Fiber preparation
When using Tray 24
In case of a looped cable, coil the loops and store
them in the space in front of the tower of the closure (loops can
be stored around the tower as well).
6 .1.2 Remove the loose tubes of the to be spliced fiber
bundles up to 150 mm from the cable jacket (see drawing 6 .1.4).
6 .1.3 Degrease the fiber bundle. Slide the transportation
tubes over the fibers up to 50 mm from the cable jacket end (see
drawing
6 . 1.4).
6 .1.4 Sketch for tube installation.
6
5.9 . 1 In unused ports, a cable plug must be installed. Wrap
the gel strip smoothly between in the two blocking rings of the
cable plug. Wrap the gel until it is flush with the blocking rings. In
this case, the gel may not exceed the height of the blocking rings.