GROUP S.P.A.
MT KIT 04
42
E
N
G
L
I
S
H
On secondary Monitors, Pushbutton 2 also has the video request
function (for more information see page 43).
Switchboard call
Press the Pushbutton set in this mode to
send a call to the system porter Switchboard.
Single-residence intercom call
Press the Pushbutton set in
this mode to send a call to the other units (Video doorphones
and/or Telephones) set to the same call address.
By lifting the handset, the receiver of the call communicates with
the caller.
The communication is ended by hanging up the handset.
In any case, a call from the external unit always has priority over an
intercom call. In this case, users who are already speaking will hear
a tone similar to the ringtone in the handset if the latter is for them,
or otherwise a triple signal tone.
To answer the call from the external unit, simply lift the handset of
any free unit or hang up and lift the handset of a unit engaged in
the intercom call.
Activation of communication with the external unit interrupts the
intercom conversation previously in progress.
An intercom call does not have priority over a conversation/call with
the external unit.
In this case, during an intercom call attempt, the LED will flash for a
few seconds to signal that the system is engaged.
Two-residence intercom call
Press the Pushbutton set in this
mode to send a call to the other units (Video doorphones and/or
Telephones) set to the two-residence call address, as indicated in
the table on page 39.
By lifting the handset, the receiver of the call communicates with
the caller. The communication is ended by hanging up the handset.
In any case, a call from the external unit always has priority over an
intercom call.
In this case, users who are already speaking will hear a tone
similar to the ringtone in the handset if the latter is for them, or
otherwise a triple signal tone.
To answer the call from the external unit, simply lift the handset of
any free unit or hang up and lift the handset of a unit engaged in
the intercom call.
Activation of communication with the external unit interrupts the
intercom conversation previously in progress.
An intercom call does not have priority over a conversation/call with
the external unit.
In this case, during an intercom call attempt, the LED will flash for a
few seconds to signal that the system is engaged.
Doctor function management
The Doctor function enables
automatic activation of the door lock release with call to the
address of the Video doorphone and/or Telephone where the
function was activated, by the external unit.
With the function activated, the signalling LED stays on. The Doctor
function is enabled or disabled by pressing the pushbutton set for
that function for 2 seconds.
Monitor ringtone selection procedure
The user can select the Monitor ringtone from a list of available
ringtones, carrying out the following procedure:
(1)
Keep the Pushbutton
pressed until a confirmation tone
sounds (this operation is only possible with the system in
standby mode; otherwise the signalling LED will flash to warn
the user).
(2)
Press and release the Pushbutton
:
once (a confirmation tone sounds) to change the call ringtone
from external unit.
twice (2 confirmation tones sound) to change the ringtone from
switchboard.
three times (3 confirmation tones sound) to change the door
bell ringtone.
Further pressing of the Pushbutton
repeats the sequence
described above.
After the last time the Pushbutton
is pressed, wait for a
confirmation tone before going to the next stage.
(3)
Press and release the Pushbutton
to scroll the various
available ringtones in sequence. To hear the same ringtone
again, keep the Pushbutton
pressed.
(4)
Lift and then hang up the handset to confirm selection of the
last ringtone heard and to exit (at any time) the Monitor
ringtone change mode. On exiting Monitor ringtone change
mode a confirmation tone will sound. The Video doorphone
now resumes its normal operation.
