Comelit 49808, Инструкция по эксплуатации

Страница: 30 / 80

User’s Manual
20
Highlight the box beside
DVR Name and press the button. A virtual keyboard appears allowing you to enter the
DVR name to be registered on the DVRNS server.
Highlight the
Check
box and press the button to check whether or not the name you entered can be used.
NOTE: The DVR name you entered should be checked by selecting Check, otherwise the DVRNS changes will
not be saved.
When entering no name or a name already registered on the DVRNS server, an error message displays.
Highlighting Save and pressing the button registers the DVR on the DVRNS server. Proper DVRNS settings will
display the help desk information of the DVRNS server in the box beside
Help Desk
.
Highlight the WebGuard tab, and the WebGuard screen displays.
Highlight Use WebGuard Service and press the button
to toggle between On and Off. See Appendix – WebGuard
for detailed descriptions of the WebGuard service.
Highlight the box beside
Port
and press the button. Set
the port number used when accessing WebGuard by using
the
Up
and
Down
arrow buttons to increase or decrease the
numbers.
Figure 21 — WebGuard setup screen.
Notification
The DVR can be set up to send an email or to contact a computer running RAS (Remote Administration System) when
an event occurs.
Highlight Notification in the Network menu and press the
button. The
Notification screen displays. You will be
able to change the Mail and Callback settings.
Figure 22 — Notification Mail setup screen.
Highlight
Enable
and press the button to toggle between
On and Off. You will only be able to change the settings if
Mail is enabled.
Highlight the box beside
SMTP Server
and press the
button. A virtual keyboard appears that you can use to enter
the IP address or domain name of the SMTP server.
NOTE: You will need to get the IP Address or domain
name of the SMTP Server from your network
administrator.
NOTE: You can use the domain name instead of IP
address if you already set up the DNS Server
when setting up the LAN.
Highlight the box beside Port and press the button. Use the arrow buttons to enter the SMTP Server port number
obtained from your system administrator. The default port number is 25.
Highlight Use SSL/TLS and press the button to toggle between On and Off. When it is On, the DVR can send an
email via an SMTP server requiring SSL (Secure Sockets Layer) authentication.