7
www.combisteel.com
The dryer is equipped with an ON/OFF Power Switch, Speed Control Switch and Hot/Cold Switch for option if
desired. The factory default setting for the Power Switch “ON”, Speed Control Switch “HIGH” and Hot/Cold Switch
“HOT”. All the switches are located inside the dryer - left side of the water collection tray. To access, remove the
water collection tray and it is clearly shown.
8. MAINTENANCE AND CLEANING INSTRUCTIONS
CAUTION on HEPA: Failure to replace a used / dirty HEPA filter can cause overheating of the hand dryer’s motor
or heat element then may invalidate your warranty right. It is recommended to clean it once/week.
1. This hand dryer is equipped with removable intake air pre-filter and a replaceable HEPA filter.
2. Regularly check filter status is required. High traffic may require more frequent replacement of the HEPA filter.
3. The removable intake air pre-filter can be cleaned and re-used.
4. Replacement filters can be purchased through your dealer where you purchased the hand dryer.
5. HEPA filter is recommended to be cleaned by a vacuum cleaner.
CAUTION on Water Collection Tray: Regularly check water collection tray’ s water level from its front viewer and
empty the water. Clean the tray then replace it. Full tray will overflow onto the floor.
CLEANING
All surfaces of the hand dryer can be cleaned with a soft cloth and no-abrasive, non-caustic cleaning solutions.
Provided cleaning brush should be used for cleaning the drain hole in the bottom of the drying cavity.
9. DIAGNOSTICS & REMEDIES
SYMPTOM
CORRECTIVE ACTION
Hand dryer fails to start
Check power supply is turned on and the power switch on hand
dryer is on.
Check for foreign objects in the drying cavity that maybe blocking
the sensors.
Insert hands a little further into the drying cavity to active sensors.
Hand dryer turns on/off erratically
Clean sensor area inside the drying cavity.
No hot air
Heater is not workable if ambient temperature is more than 25
℃
.
Check heater fuse or heater assemble isn’t broken.
Low airflow
Turn speed control switch at position of “H”
Hand dryer locked
Hand dryer will be locked by program if voltage changed range is
more than 15%.
If long time without operation the hand dryer locked. Turn off the
hand dryer several minutes then turn it on.
10. LIMITED WARRANTEE
This hand dryer has a 1year warranty from the date of purchase for any manufacturing defect. It covers
replacement of defective parts except when caused by improper use of the hand dryer. This warranty is only
valid if the form card has been properly filled up with the vendor stamp. For any warranty claim you should
contact your local distributor or manufacturer.
Model: ……………………………………….
Serial No.: ………………………………………….
Distributor: ………………………………..
Customer: ………………………………………….
Address: ………………………………..………………………………..……………………………………………..
Tel No.: ……………………………………..
Fax No.: ………………………………………………
Date of purchase: ………………………………..………………………………..………………………………..
For Seller: ………………………………….
Signature & Stamp: …………………………….
