6
www.combisteel.com
6. INSTALLATION
CAUTION Improper mounting could result in personal injury or property damage.
1. Use the mounting template
provided to mark the locations for the
8 screws to attach the wall mounting
bracket to the wall.
2. It is recommended that at least 2 of
the 6 screws for the unit be fastened
into a wall stud or support.
3. To use the hollow wall plugs
included with the wall mounting kit,
pre-drill the wall in the marked
locations using a 6/25" (6mm) drill,
insert the wall plugs and tap flush to
the wall.
4. Complete the attachment of the wall
mounting bracket to the wall with the
6 mounting screws.
5. If the hand dryer supplied with cable
& plug then hang it on bracket.
6. If the hand dryer is supplied without
cable plug and please open the power
supply kit cover on hand dryer back
then connect it as follows <Power
should be OFF>:
A. Connect the live wire (Coloured
Brown, Red, or Black) to the terminal
block marked “L”.
B. Connect the neutral wire (Coloured
Black, Blue) to the terminal block
marked “N”.
C. Connect the ground wire (Coloured
Green & Yellow) to the terminal block marked “E”.
Replace power supply kit cover then hang dryer on bracket.
7. Remove the water tray from the bottom of dryer, and complete the attachment of the dryer with left 2 screws.
8. Before replace water tray, there is an option to run the dryer heater On or OFF and air speed High or Low. The
switch is clearly marked.
9. Replace the water tray.
10. Open the pre-filter to install the HEPA filter if necessary. HEPA’s rubber ring is at the top.
11. Connect plug to power supply socket or turn on power.
7. HOW TO USE
1. No-touch operation.
2. There is a blue LED light to guide user to the air flow.
3. The hand dryer will start automatically when hands are inserted.
4. Slowly move your hands up and down through the air stream for
7-10 seconds.
5. The hand dryer will stop automatically after hands are removed.
LED Display: The LED display provides information about the operation
and servicing needs of the hand dryer.
A. Drying time and welcome diagram
B. Power indicator
C. Air sterilization indicator
D. Self-check indicator
