USER MANUAL FOR RA-7100
RA-7100 II2 QI
Copyright - refer to title page
Page 45
ENU Status : 1-0-0
modem is required. It is the phone number to dial the equipment. Only the
phone number pre-defined in this field, will it be allowed to dial the
equipment. It is required to manually enter the phone number. Up to 5 phone
numbers are allowed. The use of phone number authentication can avoid
unauthorized use of the OMT. In addition, it can prevent the equipment
receiving piles of spam short messages, thus help the operator greatly
reduce the cost.
Report Config
The Report No. is the SIM card number of the modem built into the OMC
Server computer. The equipment will send alarm SMS to this number.
If remote communication is needed via modem, users have to enable SMS
mode and set the report phone No. by entering the SIM card number of the
equipment built-in modem.
SMSC No.
It specifies the SMS center. In case users choose SMS communication,
users have to set the service No. of SMSC for the first installation, so that the
alarms can be sent to OMC.
Table 15: Comm.Config.
4.3.14 DATA MAINTENANCE
Refer to OMT V4.0 Software Product Manual.
4.4 NON-VOLATILE
MEMORY
A non-volatile storage device on the MCU holds the configuration of the equipment. The following
information is preserved in the event of power-loss:
Network Configuration
Device ID
SMS report mode including SMS center number and OMC report number setting
Operating Parameters
Pre-ATT
Switch
Output Power
Gain
Downlink Input Power
Alarm thresholds
End of Section
