ADJUSTING THE SCRUBBING BRUSH HEAD SIDE SPLASH GUARD
If the side splash guards of the brush head body are not positioned correctly they cannot do their work properly, namely convey the dirty detergent
solution towards the squeegee, therefore the height of the splash guard needs to be adjusted.
This operation can be done with the brush head body in the work position, proceeding as follows:
1. Sit on the driver’s seat.
2. Insert the key (1) into the main switch on the control panel. Set the main switch to "I" (
Fig.1
).
3. Using the knob (2) on the control panel (
Fig.2
), select the “SCRUBBING WITH DRYING” work program.
4. Press the drive pedal (3) (
Fig.3
) to begin moving the machine.
5. As soon as the brush head and the squeegee have reached their working positions, perform the procedure for securing the machine (see the
).
CAUTION
: it is recommended to wear the appropriate PPE (Personal Protective Equipment) for the work to be carried out.
6. Go to the front left-hand side of the machine.
7.
Adjust the height of the splash guard with respect to the floor, tighten or loosen the knob (4) until the splash guard touches the floor along its
entire length (
Fig.4
).
N.B.
: Both the front and rear of the splash guard need to be at the same height off the floor.
8. Repeat the operations just carried out also for the right side centre as well.
3
4
1
1
3
4
2
2
9. Once the adjustment has been completed, engage the stopper lever (4) (
Fig.7
).
Adjusting the tilt of the squeegee body:
10. Loosen the stopper knob (7) for the squeegee's tilt adjustment knob (8) (
Fig.8
).
11.
Adjust the tilt of the squeegee body's rubber blades in relation to the floor, tighten or loosen the knob (8) (
Fig.9
) until the squeegee body's rubber
blades are bent outwards by about 30° in relation to the floor, in an even manner along their entire length.
N.B.
: Figure 9 indicates the direction of rotation for tilting the squeegee towards the rear of the machine (
Fig.10
). Turn it in the opposite
direction to rotate the squeegee towards the front of the machine.
N.B.
: Check for proper adjustment by looking at the instrument (9) positioned on the squeegee body (
Fig. 6
).
12. Once the adjustment has been completed, tighten the stopper knob (7) (
Fig.11
).
5
6
4
4
5
5
6
9
7
4
11
7
9
10
8
8
8
7
DISPOSAL
To dispose of the machine, take it to a demolition centre or an authorised collection centre. Before scrapping the machine,
it is necessary to remove and separate out the following materials, then send them to the appropriate collection centres
in accordance with the environmental hygiene regulations currently in force:
• Brushes.
• Felt.
• Electric and electronic parts*
• Batteries.
• Plastic parts.
• Metallic parts.
(*) In particular, contact your distributor when scrapping electric and electronic parts.
33
Содержание C100 ESSENTIAL Series
