HANDLING THE PACKAGED MACHINE
Gross weight of machine with packaging is:
• C85 2018= 615kg
• C100 2018= 640kg
The overall dimensions of the package are: A= 133cm B= 214cm C= 180cm
ATTENTION
: It is recommended that all the packaging components be kept for any future machine
transportation.
ATTENTION
: Move the packaged product with handling equipment that complies with legal requirements
regarding the size and mass of the packaging.
HOW TO UNPACK THE MACHINE
The machine is shipped in specific packaging. To remove it, proceed as follows:
1.
Place the lower part of the outer packaging in contact with the floor.
N.B.
: use the pictograms printed on the box as a reference.
2. Remove the outer package.
WARNING
: the machine is contained in specific packaging materials, whose elements (plastic bags, staples, etc.) can pose potential hazards,
and must not be left within reach of children, disabled persons, etc.
CAUTION
:
it is recommended to wear the appropriate PPE (Personal Protective Equipment), suitable for the work to be carried out.
3. Insert a ramp in the rear part of the machine.
ATTENTION
: the ramp gradient must not be such as to cause damage to the machine as it comes down.
4. The machine is fastened to the platform with wedges, remove these wedges.
5.
Take the machine off the pallet via the ramp.
CAUTION
: during this operation, check there are no people or objects near the machine.
HOW TO MOVE THE MACHINE
To transport the machine safely, proceed as follows:
1. Check to make sure that the solution tank and the recovery tank are empty. If this is not the case, empty them (see the sections titled “
2. Place the machine on the transport vehicle.
WARNING
: Ensure the machine complies with the directives in force in the country of use (e.g. 2014/47/EU), so that it cannot slide or tip over.
MACHINE SAFETY
The procedure for securing the machine, thus allowing the operations to be performed under conditions of complete safety, is as follows:
1. Sit on the driver’s seat.
2. Insert the key into the main switch on the control panel. Set the main switch to "I" by turning the key a quarter turn clockwise (
Fig.1
).
3. Using the i-drive control knob (
Fig.2
), select the “transfer” program (see “
N.B.
: in this way, both the brush head body and the squeegee body will move to their idle position.
4. Shift the direction lever to the “idle” position, moving it in the direction shown by the arrow (
Fig.3
).
5. Move the main switch to the "0" position by turning the key a quarter turn anti-clockwise (
Fig.4
). Remove the key from the main switch.
6. Disconnect the battery connector from the machine's main system connector (
Fig.5
).
3
1
4
5
2
13
Содержание C100 ESSENTIAL Series
