COMAC C100 ESSENTIAL Series, Руководство по эксплуатации и обслуживанию

Страница: 14 / 40

PREPARATION OF MACHINE
TYPE OF BATTERY TO BE USED
The batteries must meet the requirements laid out in the norms: DIN/EN 60254-2 and IEC 254-2 series L. To carry out the work well the machine
must have a 36V power supply , we recommend using a 36V 360Ah/C
5
traction battery box.
BATTERY MAINTENANCE AND DISPOSAL
For battery maintenance and recharging, respect the instructions provided by the battery manufacturer.
When the batteries reach the end of their working life, they must be disconnected by expert, trained personnel then removed from the battery
compartment with the aid of suitable lifting devices.
N.B. : dead batteries are classified as dangerous waste and as such must be delivered to an authorised body for disposal.
INSERTING THE BATTERIES IN THE MACHINE
To fit the batteries inside the machine, contact a COMAC assistance centre technician
.
WARNING:
COMAC declines all responsibility for any damage to property or injury to persons in the event that the batteries are replaced by
an unauthorised technician.
RECHARGING THE BATTERIES
The batteries must be charged prior to the first use, and when they don't provide enough power for tasks that could formerly be performed without
difficulty.
ATTENTION: to avoid any permanent damage to the batteries, it is essential to avoid their complete discharge; begin recharging them within
a few minutes of noting the "discharged batteries" signal.
ATTENTION : never leave the batteries completely run down, even if the machine is not being used.
To recharge the batteries, proceed as follows:
1. Bring the machine to the battery recharging area.
N.B.
: Park the machine in an enclosed place, on a flat and level surface; near the machine there must be no objects that could either damage
it, or be damaged through contact with it.
WARNING : the battery recharging area must comply with the requisites of Standard CEI EN 50272-3, or those currently in force in the country
of use.
2. Make sure the machine is in a safe condition (see chapter “ MACHINE SAFETY MEASURES ”).
3. Grip the handle for moving the seat mounting plate and turn the plate to the maintenance position ( Fig.1 ).
4. Disconnect the battery connector from the machine's main system connector ( Fig.2 ).
ATTENTION
: the following operations must be carried out by qualified personnel. An incorrect connection of the connector may cause problems
with machine functioning.
5. Connect the external battery charger cable to the battery connector.
N.B.
: the coupling connector of the battery charger is consigned inside the bag containing this instruction booklet, and must be assembled on
the cables of the battery charger as indicated in the instructions.
CAUTION : before connecting the batteries to the battery charger, make sure it is suitable for the batteries used.
14
1 2 6 3
7
4 5
8 9 10 11 12