Columbia 12ABW32G897, Руководство оператора

Страница: 12 / 28

12 S
ection
3 — A
SSembly
& S
et
-U
p
Adjustments
Cutting Height (Standard Wheel)
There is a cutting height adjustment lever located above the rear
left wheel. See Figure 2-15.
Figure 3-15
1. Pull lever out and away from mower.
2. Move lever forward or back for desired cutting height.
3. Release lever towards mower deck.
NOTE:
On the standard wheel units, this lever adjusts the rear
and front wheel height simultaneously. On caster wheel models,
it adjusts the rear wheel height only.
Cutting Height (Caster Wheel)
If equipped, the caster wheels cutting height are determined by
selecting one of six positions on each caster assembly. Refer to
Figure 3-16.
(a)
(b)
Figure 3-16
Attaching Side Discharge Chute
Your mower is shipped as a mulcher. To convert to side discharge,
make sure grass catcher is off the unit and mower rear discharge
door is closed.
1.
On the side of the mower deck, lift the mulch plug. See
Figure 3-13.
Deck
Stud
Mulch
Plug
Figure 3-13
2. Slide two hooks of side discharge chute under hinge pin
on mulch plug assembly and position hole in the chute
over and on to the deck stud located behind the discharge
opening. See Figure 3-13. Lower mulch plug.
3. Secure the chute to the mowing deck using the wing knob
included in the manual ba
g. Hand tighten the wing knob onto
the deck stud. See Figure 3-14.
Figure 3-14
NOTE:
Do not remove side mulch plug at any time.