SC Scanner Instruction Manual
Page 4 of 23
11
1
Tools Required
To maintain the SC Scanner the tools listed below are required. The tools are generally
available; they are not the responsibility of Colortrac to supply.
1. Wristband
Anti-static and cable.
2. Pencil
HB Lead, or similar
3. 7mm Nutdriver.
To remove and fit M5 nuts.
4. 1.5mm Allen Key
or 1.5mm Hex Key
5. Medium Pozi-drive screwdriver.
PZ1 x 80mm length.
6. Small Pozi-drive screwdriver.
PZ0 x 60mm length.
7. Small Flat Screwdriver
3mm blade x 65mm length
(approx.)
8. Medium Flat Screwdriver.
6mm blade
(approx.)
9. Pliers.
Flat nosed pliers, short serrated.
2
Photos Information
Some photos in this manual were taken during pre-production, and various stages of the
SC Scanner
’s development. Some colours / backgrounds / designs shown may vary from
the actual scanner being worked on. Some background panels may be shown in the
photo to be removed when they actually
don’t need to be; however the instructions are
still correct and should be followed as described.
