Color Kinetics LL011L360WW120000, Руководство по обслуживанию

Страница: 20 / 42

20
Chapter 4
Figure 21 Tools.
4.1 Required tools
In this part of the manual a subset of the following tools are required for each
specific task.
Quantity Item Specification Reference
4 pieces
per meter Z-clamps Special for luminous textile (alternative: flat washers 10 × 1 mm) A
1 Glue gun B
1 Heat cutter with blade Heat cutter: for example, HSGM HSG-0 (check voltage)
Blade: for example, HSGM Type R heat cutter blade C
1 Junior hacksaw For PCB shortening on an RGB Light Engine D
1 Pair of scissors For the textiles E
1 Utility knife For the textiles F
1 Cutters For coil springs G
White gloves H
1 Felt tip pen To mark the cutting line I
1 Rolling knife For example, KitchenAid with modified blade: it must be blunt, not sharp J
1 Screwdriver Flat-head 1.2 × 6.5 mm (3/64 × 1/4 in) K
1 Needle Special stomp needle or other similar item to push fabric in corner L
1 Screwdriver Pozidriv 2 screwdriver M
1 Allen key 3 mm Allen key to open the bus covers N
1 Tape measure Used in during the resize of the Light Engine O
2 Tables Approximately 0.8 × 1.8 m, same height
O
3 mm (
1
/
8
in)
N M
L K
J I
H
G F E
D C B A