Color Kinetics LL011L360WW120000, Руководство по обслуживанию

Страница: 38 / 42

38
Chapter 6
C
Important
Wear gloves during the stretching
to prevent damage to the fabric.
D
Note
If product is produced after 2019
week 22 the diffuser fabric is 20
mm longer.This is for easy fabric
re-stretching if required.
In that case follow steps 1 to 5
and only remove the coil springs
from the front fabric in the area
that you want to do re-strecting.
After that you can pull gently on
the diffuser fabric to smoothing
out wringkles.
6.2 Required replacement parts
Quantity Item Specification Reference
Front textile Enough for Luminous Textile size
+ 200 mm each side
Diffuser textile Enough for Luminous Textile size
+ 200 mm each side
10 Frame springs
(spare) Special for Luminous Textile A
Calculate, see
section
6.1
Coil springs
(spare) Special for Luminous Textile
5.4 mm (0.21 in) B
Figure 43 Replacement parts.
6.3 Overview
A video is available via your local Signify representative.
1 Prepare two tables with the same height.
2 Put the Luminous Textile with textile up. The driver box must be placed
between the tables.
3 Lift the rails from the corners and place the z-clamps to get access to
the springs.
4 Use a long needle to lift the springs out of the rail. Start from the corners.
Remove all springs.
5 Carefully remove the textile from the corners with the needle.
6 Remove the old textile.
7 Clean the corners from glue residue.
8 Position the new textile over the frame.
9 Switch the Luminous Textile ON. Verify that there are no disturbing
fabric failures.
10 Cut the textile around 200 mm around the frame.
11 Take the roller and place the springs for the first edge. Start from the
shorter edge of the Luminous Textile.
12 Go to the opposite side of the Luminous Textile and stretch and place the
second spring.
13 Do the third side of the Luminous Textile very gentle.
14 The last side must be stretched hard while the spring is placed. Pull textile
down hard.
15 Cut the springs in the corners.
16 Cut the corners with the scissors about 5 mm (0.2 in) oversized.
17 Use the needle to fixate the corners of the textile with the thermal glue.
18 With the heat cutter, cut the excess textile below the spring.
19 Remove the z-clamps, the rails move down automatically.
B A