19
SMARTHUB
5.
FAQs
Review the section MOBILE APP for information about display screen alerts and
management. Answers to common questions appear below.
When is the High/Low Speed Warning Signal activated?
This signal will activate when spindle RPMs are either higher or lower than the pre-
set value programmed by user or automatically set by the program when selecting
one of the spindle models preprogrammed into the system.
What do the Speed Signal Indications actually mean?
•
Low pressure (low speed)
•
Over pressure (high speed)
•
Heavy load on the spindle or incorrect machining conditions, spindle
malfunction (low rpm’s)
What are the High/Low Speed Warning Signal Options?
•
Option 1: Stays as visual warning on screen, until the operator acknowledges
it.
•
Option 2: Stop cycle until machine operator checks what is wrong.
Why is the Low Battery Signal warning always lit?
•
The "low battery signal" timing is triggered by the battery condition, but goes
back to zero level when spindle stops transmitting (stops)
•
If battery was not replaced when spindle operation resumes; (rotational speed
+ spindle data transmission) a "low battery" warning will appear, and remain
on until spindle stops again and so on, or until battery is replaced.
•
Therefore the trigger for that signal is the low battery level and the terminator
is "spindle stop"
•
The battery life is long, at least ~750 hr.
•
It is highly recommended to replace battery when necessary, otherwise no
data will be transmitted and the SmartHUB will no longer "recognize" the
spindle. This can pose safety problems
FA
QS
