LCD Display
Temperature Adjustment Buttons
Massage System Button
On/Off Button
Heat Button
Water Filter Button
IMPORTANT:
If spa is turned off, the remote control will not
work. Insert the spa plug, reset the GFCI, and then use the
remote control.
When the remote control is activated, the LCD display screen
will stay on for about 15 seconds. After that, it will automatically
shut down. To use the remote control again, press any button.
NOTE:
Press any button on remote control to synch with spa
panel when operating the spa panel.
WARNING !
Do not put the remote control in the water.
If the remote control falls into water, take it
out of the water immediately.
Damage to the remote control caused by immersion in water
is not covered under your warranty.
Pairing Instructions:
The remote control that comes with your spa is already paired with the spa. If the spa pump or remote control are replaced, you have to pair them again
according to the following instructions:
1. Connect the pump to a power source and press the reset button on the GFCI.
2. Press the button on the control panel for 3 seconds. Then the indicator will start to flash, and the pump has entered the pairing mode.
3. Press the button on the remote control for 3 seconds, and the LCD display on the remote control will show "PIR".
After several seconds, it will display "PAS". The remote control is ready to use.
NOTE:
If the pairing operation did not finish within 20 seconds, it must be restarted.
NOTE:
The distance between the remote control and the pump must be less than 10 m (33 ft.).
Battery Warnings:
• Do not mix old and new batteries.
• Do not mix the different types of batteries. Do not mix alkaline, standard (Carbon - Zinc), or rechargeable (Nickel - Cadmium) batteries.
• Ensure batteries are installed correctly with regard to polarity (+ and -).
• Do not short-circuit the battery.
• Never attempt to recharge primary batteries as this may cause leakage, fire, or explosion.
• Rechargeable batteries are to be removed from this product before being charged.
• Never attempt to disassemble or open batteries as this can lead to electrolyte burns.
• Remove batteries from equipment which is not to be used for an extended period of time.
• Exhausted batteries are to be removed from this product.
• Do not dispose of product and its batteries in fire. Check your local regulations for proper disposal instructions.
• Batteries shall not be exposed to excessive heat such as sunshine, fire or the similar.
• Keep batteries out of the reach of children.
• Only use 2x CR2032 batteries.
To replace the battery:
11
303021236526_14.0x21.0cm_90443E_20N-OEM-381_美国规SPA主体说明书
