background image

 

 

TROUBLESHOOTING CHART 

 

 

NOTE:

 Troubleshooting problems may have similar causes and solutions. 

PROBLEM POSSIBLE 

CAUSE 

SOLUTION 

Motor will not 
run or start 

Power cord not plugged in 

Plug cord into grounded outlet 

Pressure Switch in “OFF” position 

Turn switch to “ON” position 

Wrong gauge wire or length of 
extension cord 

Check chart on page 2 for proper gauge wire and cord 
length 

Motor thermal overload switch 
tripped 

Turn air compressor off, wait until motor is cool, then 
check motor circuit breaker 

Fuse blown or circuit breaker 
tripped 

-Replace fuse or reset circuit breaker 
-Check for proper fuse amperage 
-Check for low voltage conditions 
-Disconnect any other electrical appliances from circuit 
or operate compressor on its branch circuit 

Air tank pressure exceeds preset 
pressure switch limit 

Motor will start automatically when tank pressure drops 
below tank cut-in pressure. 

Check valve stuck open 

Remove and clean or replace 

Loose electrical connections 

Contact authorized service center 

Possible defective motor, capacitor 
or check valve 

Contact authorized service center 

Motor runs 
continuously 
when in the 
Start/Stop option 

Pressure switch does not shut off 
motor when air compressor 
reaches cut-out pressure and 
safety relief valve activates 

Move the pressure switch to the OFF position. If the 
motor does not shut off, unplug the air compressor. If the 
electrical contacts are welded together, replace the 
pressure switch. 

Air compressor not large enough 
 

Check air requirement of accessory used. If it is higher 
than CFM and pressure supplied by compressor, a 
larger compressor is needed. Most accessories are 
rated at 25% of actual CFM while running continuously.

Regulator does 
not regulate 
pressure 

Dirty or damage regulator 
internal parts. 

Replace regulator. 

Low pressure 
or not enough 
air 

Fittings leak 

Check fittings with soapy water. Tighten or reseal 
leaking fittings. But do not over tighten. 

Tank drain valve is open 

Close drain valve 

Restricted air intake 

Clean or replace air filter element. 

Prolonged or excessive use of air 

Decrease amount of air used 

Hole in air hose 

Check and replace if necessary 

Tank leaks 

   

WARNING

   

Replace unit immediately. DO NOT attempt to repair. 

Valve leaks 

Check and replace worn parts. 

Moisture in 
discharge air 

Condensation in air tank caused by 
high level of atmospheric humidity 
or air compressor did not run long 
enough. 

Drain air tank after each use. Drain air tank more often 
in humid weather and use an air line filter. 

Overheating 

Poor ventilation 

Relocate compressor to an area with cool, dry and 
well-circulated air. 

Dirty cooling surfaces 

Clean all cooling surfaces of pump and motor 
thoroughly. 

Leaking valve 

Replace worn parts and reassemble with new seals. 

- 9- 

Содержание CM01213-15












Отзывы: