Cole Parmer POLYSTAT, Инструкция по установке и эксплуатации

Страница: 19 / 49

Section 3 Installation
3-7
Cole Palmer
Filling Requirements
Draining
CAUTION
CAUTION
Ensure the reservoir drain port on the front of the unit is
closed
and that
all plumbing connections are secure. Also ensure any residue is thoroughly
removed before filling the unit.
Before using any fluid refer to the manufacturer’s MSDS and EC
safety data sheets for handling precautions.

To avoid spilling, place your containers into the bath before filling.
With a low level WARNING the unit continues to run, with a FAULT the
unit will shut the refrigeration, pump and heater will shut down, see Section
7. The low level warning is at approximately 4 cm (1 5/8”) below the top, the
low level fault is at approximately 5.5 cm (2 1/8”).
Avoid overfilling, oil-based fluids expand when heated.

When pumping to an external system, keep extra fluid on hand to maintain
the proper level in the circulating lines and the external system.
NOTE Monitor the fluid level whenever heating the fluid.

Before draining any fluid refer to the manufacturer’s MSDS and EC
safety data sheets for handling precautions.

Ensure the fluid is at a safe handling temperature, ~55°C. Wear
protective clothing and gloves.

place a suitable vessel underneath the drain. If desired, attach an •
8 mm id tube on the drain.
slowly • turn the drain plug until flow is observed.
Additional Fluid
Precautions
When working with fluids other than water:
Do not use any fluid until you have read and understood the label and •
the Material Safety Data Sheet (MSDS).
Do not blend any fluids.
•
Ensure any fluid residue or any other material is thoroughly removed •
before filling the unit with a different fluid.
Always wear protective clothing, especially a face shield and gloves.
•
Avoid spattering on any of the unit's components, always •
slowly
add fluid.
When adding, point the opening of a container away from yourself.
Use fume hoods.
•
Do not allow any ignition sources in the vicinity. •